2020-08-28
General automatic rotating hot pot conveyor belt cracks may be caused by the following reasons
1. Due to the limitation of space size, the number of bending times of the conveyor belt will be more.
2. The joint has been vulcanized more than twice for various reasons.
3. Reasons for disconnection of automatic rotating hot pot conveyor belt connector
1. Generally, the diameter of the reversing roller is small, and the bending stress of the automatic rotating hot pot conveyor belt is large.
2. When the quality of the vulcanized joints of the conveyor belt is poor, especially if it has been vulcanized more than two times, the joint strength is significantly reduced, or the canvas layer is cut off or polished during glue bonding, and the strength is reduced here.
3. For the conveyor that can be transported in reverse, because it can only be in one direction when it is lapped up and down, it is easy to be scratched by the sharp corners of some hard equipment on the belt.
4. The working cycle of the conveyor is short, and the starting and stopping are frequent, resulting in large tension.
The above is an introduction about the occurrence of cracks on the conveyor belt. I hope it will help you. If your automatic rotating hot pot conveyor belt is torn or cracked, you should stop the machine and check it immediately to find out the reason, and don't ignore it, so as not to expand the damage range.
The 11th Yellow River Delta Green Nursery Stock Expo Opens
New Fat Loss Solutions Unveiled by Gorilla Mind
TRIPON WEALTH MANAGEMENT GROUP INC,A World-renowned Wealth Management Company
A group of college students in Washington raised funds for Trump's presidential campaign in the form of cryptocurrency
Third Wave of Vaping Is Coming? An Insight View of VOOPOO's Third Wave
Global Times: The secret of China's success in fierce domestic competition
©copyright2009-2020Fresh life